HP E1200-320 manual Fibre Channel Device Display

Table 7 Fibre Channel status

SyncLosses is the number of times loss of sync. was detected.

BadRxChars is the number of bad characters received.

LinkFailures is the number of link failure conditions.

BadCRCFrames is the number of frames received with a bad CRC.

ProtocolErrs is the number of protocol errors detected.

BadSCSIFrames is the number of bad SCSI frames detected.

UnderflowErrs is the number of underflow errors detected.

Select A to have the status information repeatedly refreshed.

•Select 2 from the Fibre Channel Status menu to display Attached Fibre Channel Devices. Figure 67 Fibre Channel device display

Fibre Channel Device Display

X.XX.XX XXXXXX XXXXXXXXXXXXXXXX

07/7/2005 08:56:22

FC Port: 0 Port id: 0x000001

R)Refresh Device Display

D)Display Device Details

X)Return to previous menu

Command, <enter> for next FC Port > r

Port 0: Requesting discovery

Doing device discovery on port 0...

Completed discovery on port 0

Fibre Channel Device Display

Version X.X XXXX

FC Port: 0 Port id: 0x000001

Port 0: TARGET DEVICE (UP)	Port id: 0x000010
HP Ultrium 3-SCSI L22W	Type: Direct Access

R)Refresh Device Display

D)Display Device Details

X)Return to previous menu

Select R to refresh the device display (as shown in the menu above) with the latest status information and perform manual FC discovery (as set in the Fibre Channel Configuration menu described earlier in this chapter).

Select D to display device details.

•Select 3 to display FC Resource Status.

•Select 4 to display FC Driver Resource Status.

82 Using the Command Line Interface