HP E1200-320 manual Creating an entry for FCP port map

NOTE: Hi-Sup Bit is only set in an Active Fabric LUN which needs to be mapped as the first device (FC LUN 00).

Select a number from the left column Num to add a device to the map. Selecting a device where LUN=’-’ adds all LUNS for this target. If the selected device is already mapped, an error message appears to warn the user about adding a duplicate device. N and P controls allow scrolling up and down the device list. X brings the user back to the Edit Map Entries display table.

Creating an entry

The user can create an empty map, or use an existing map to pre-enter devices that are not yet online. To perform this operation, the user has to know all the essential information about the device. A series of questions are asked to guide the user through the process. The questions vary based on the current map protocol.

The user is asked to:

•Select the LUN address for a device,

•The protocol/port on which device it resides,

•The Name for the device (which can be left empty),

•And the type of device

Figure 50 Creating an entry for FCP port map

Enter desired lun address > 1

Select Protocol (0 -		SCSI, X=Cancel) > 0
Enter desired Device		Name (could be empty) >
DISK_DEVICE	-	0,	TAPE_DEVICE	- 1
PRINTER_DEVICE	-	2,	PROCESSOR_DEVICE	- 3
WORM_DEVICE	-	4,	CDROM_DEVICE	- 5
SCANNER_DEVICE	-	6,	OPTICAL_DEVICE	- 7
MEDIUM_CHGR_DEVICE	-	8,	COMM_DEVICE	- 9
ARRAY_CTLR_DEVICE	-	12,	ENCLOSURE_SRV_DEVICE	- 13

Enter desired Device Type > 1

Enter device target id > 5

Enter device lun id > 0

NOTE: If the device being added is a SCSI device, the user is also asked to enter Target ID and LUN ID for the device. Target ID must already be defined in the SCSI Configuration. Otherwise, adding a device is not permitted.

NOTE: Select MEDIUM_CHGR_DEVICE for the library or robot controller.

NOTE: When creating a device that does not exist, it will be displayed with Down status.

70 Using the Command Line Interface