HP RISS Components manual Restoring the master configuration files

3.If the database server was reinstalled, run one of the following commands to restore the /db2/VolBack partition from either the version stored on the kickstart server or tape backups.

NOTE:

This will delete the content of the VolBack directory.

•/opt/bin/backup/db2BackupUtility -restore_from_kickstart

•/opt/bin/backup/db2BackupUtility -restore_from_tape

4.To restore the database, make sure the database is up by issuing the command: su – db2udb –c db2start

5.To restore DB2, run the following command. It will ask for a timestamp of a backup to restore. Normally, the last two backups of the database are kept.

/opt/bin/backup/db2BackupUtility -restore_db2

6.After the installation is finished, run /opt/bin/start on the PCC server to start the RISS system and validate that it operates correctly.

Restoring the master configuration files

Copies of the master configuration files are kept in the /usr/local/MasterConfigFiles directory on the PCC server. Whenever one of the files is changed on the kickstart server and the converter is run, the master configuration file is copied to the PCC server, and renamed to YYYY-MM-DD-hh.mm.ss_FileName. It is also backed up to tape, if application backup is enabled.

To restore this directory from the tape backup, run the following command on the PCC server:

/usr/local/tsmBackup/rotateMasterConfigBackup –restore

72 Data management