8.2.Preparing cappuccino Fig.11 (excluding DE/H TS)
Fig.11
●Make cup of cappuccino with the express coffee.
●Use a high and narrow jug,
●Place the jug under the spout so that the nozzle touches the bottom.
●Turn on the steam tap and lower the jug so that the nozzle is almost at the surface of the milk.
●Continuously move the jug up and down so that the nozzle moves in and out of the milk, causing it to froth.
●Turn off the steam tap and pour the milk into the cup.
Immediately after carrying out this operation, clean the spout with a sponge or a clean cloth so that the milk does not dry on it. Be careful as the the spout is hot and may burn your hand.
8.3. Heating a beverage
●Immerse the steam spout into the liquid to be heated;
●Gradually turn on the steam tap 9 o 10 Fig. 8; the steam that bursts in the liquid heats it to the desired temperature.
●Turn off the steam tap when the desired tempera- ture has been reached.
Immediately after carrying out this operation, clean the spout with a sponge or clean cloth. Be careful as the spout is hot and may burn your hand.
Version De/H TS/LE
●Use a high and narrow,
●Place the jug under the spout so that the nozzle touches the bottom.
●Press the steam button 10 Fig.8.
●When the programmed temperature is reached, steam is no longer emitted.
●To manually continue the heating process, the steam button must be held down.
The heating phase programmed can be interrupted at any moment by pressing the same steam button.
In the order to obtain a uniform temperature the steam spout anr relative temperature sensor on the spout must be kept clean. They should be cleaned immediately after the heating process with a clean, slightly damp cloth
The temperature can be programmed by the technician between 54°C (130°F) and 85°C (185°F)
These is only one setting, valid for both steam spouts.
Delivery time must in no case exceed 5 minutes.
The user must be very careful when carrying out this operation because, as soon as the steam button is pressed, steam is emitted at full pressure from the spout.
Do not put your hands under the spout while steam is being emitted.
8.4. Preparing tea, camomile, etc.
●Place the jug under the hot water spout and use the delivery control according to the model (Fig.8). When the desired quantity has been obtained, turn off the switch.
●Add the beverage desired.
Models S27 and DE
For these models, hot water is dispensed in specific measures (see paragraph 9, adjusting the dose of hot water).
To dispense hot water in different quantities, proceed as follows:
●Hold down the delivery control
●When the desired measure has been obtained, press the button E again to interrupt delivery.
When the dose of hot water is being delivered electronically, delivery can be interrupted by pressing the button E.
When purified water is used, these beverages often assume a darker colour.
Should the user prefer a lighter coloured drink, draw fresh water from an ordinary tap and proceed with the heating phase as described in point 8.3.
86