
Link speed and duplex settings
NOTE: This information applies only to Ethernet networks. It does not apply to wireless networks.
The link speed and communication mode of the print server must match the network hub. For most situations, leave the product in automatic mode. Incorrect changes to the link speed and duplex settings might prevent the product from communicating with other network devices. If you need to make changes, use the product control panel.
NOTE: The setting must match with the network product to which you are connecting (a network hub, switch, gateway, router, or computer).
NOTE: Making changes to these settings causes the product to turn off and then on. Make changes only when the product is idle.
1.Touch the Setup button.
2.Scroll to and touch the Network Setup menu.
3.Touch the Link Speed menu.
4.Select one of the following options.
Setting | Description | ||
|
| ||
Automatic | The print server automatically configures itself for the highest link speed and | ||
|
| communication mode allowed on the network. | |
|
|
| |
10T | Half | 10 megabytes per second (Mbps), | |
|
|
| |
10T | Full | 10 Mbps, | |
|
|
| |
100TX Half | 100 | Mbps, | |
|
|
| |
100TX Full | 100 | Mbps, | |
|
|
|
|
5.Touch the OK button. The product turns off and then on.
126 Chapter 7 Manage and maintain | ENWW |