Husqvarna PT26 D manual Cutting unit, Antifreeze

Presentation

IMPORTANT INFORMATION:

Never fill a hot engine with cold coolant. Risk of extensive engine damage.

Only fill antifreeze and water ready mixed in a 50/50 ratio.

Check the level when the engine has been driven for a few minutes after filling. There could have been air in the system which has now been released.

Antifreeze

Only use a glycol based antifreeze that is approved by the applicable norms BS 6580:1992 or ASTMD 3306-89 or AS 2108-1977 (indicated on the packaging).

The antifreeze agent must be intended for use with light alloy engines.

Your Husqvarna supplier can provide the correct type of antifreeze agent.

IMPORTANT INFORMATION:

If you use the incorrect type or mix different types of antifreeze agents, a chemical reaction may occur, which causes overheating and severe engine damage. These are not covered by the warranty.

Use antifreeze agent all year round and even in climates that do not have a risk of frost. The antifreeze agent contains additives that protect the engine cooling system against corrosion.

Glycol	Water	Freezing point
60 %	40 %	- 47 ¡C
50 %	50 %	- 37 ¡C
40 %	60 %	- 25 ¡C

Mixing table

Cutting unit

PT 26D can be equipped with cutting unit, Combi 132 with a 132 cm cutting width or Combi 155 with a 155 cm cutting width.

The cutting unit is driven by a v-belt, a power take-off shaft and a propeller shaft from the engine. It is engaged by an electro magnetic clutch, which is located in front of the engine’s flywheel.

The Combi unit functions as a BioClip unit when a BioClip plug is fitted under the unit cover, but can be

set to rear ejection by removing the BioClip plug.

Cutting unit Combi 155

The unit’s BioClip function finely chops the grass several times before returning it to the lawn as fertiliser. The rear ejector ejects the clippings behind the unit without finely chopping them.

Cutting unit Combi 155 can be mounted 8 cm (3 1/8")

27