Lubrication
Filling engine oil
The oil filler opening is on the valve cover. Never fill above the “FULL” mark (upper notch on the dipstick).
Fill the oil slowly. Reinstall the dipstick before starting the engine. Start and run the engine at idling speed for approx. 30 seconds. Turn off the engine. Wait 30 seconds and check the oil level. If necessary fill so that the oil comes up to the “FULL” mark on the dipstick.
Changing the Engine Oil |
| ||
The engine oil should be changed the first time after | Oil filler opening | ||
25 hours running time. It should then be changed after |
| ||
every 250 hours of running time. |
| ||
|
|
|
|
|
|
|
|
WARNING:
Engine oil can be very hot if it is drained directly after stopping the engine. Allow the engine to cool somewhat first.
Change the oil when the engine is at a temperature hot enough for any dirt to flow out easier.
IMPORTANT INFORMATION:
Used engine oil is a health hazard and must not be disposed of on the ground or in nature; it should always be disposed of at a workshop or appropriate disposal location.
Avoid skin contact; wash with soap and water in case of spills.
1. Position the wheels fully to the left. | Drain plug |
2.Place a vessel underneath the drain plug.
3.Remove the dipstick. Remove the drain plug on the oil pan and allow the oil to run into the vessel.
4.Clean and install the drain plug and tighten.
5.Replace the oil filter if necessary. See
“7. Replacing the engine’s oil filter” on page 57.
6.Fill with oil. See “Filling engine oil” on page 56.
7.Run the engine to operating temperature, then check that there is no leakage from the oil plug or oil filter.
8.Check the oil level, top up if necessary.
56
