Husqvarna PT26 D manual Lubrication Schedule, General, Lubricating the cables

Lubrication

Chapter 7: Lubrication

Lubrication Schedule

When in daily use, the weekly lubrication (40 h) schedule should be carried out twice a week.

General

The position numbers for the lubrication points refer to the lubrication instructions on the following pages.

Remove the ignition key to prevent unintentional movements during lubrication.

When lubricating with an oilcan, it ought to be filled with engine oil. When lubricating with grease, unless otherwise stated, grease 503 98 96-01 or another chassis or ball bearing grease offering good corrosion protection shall be used.

With daily use, the machine shall be lubricated twice weekly.

Wipe away excess grease after lubrication.

Lubricating the cables

Grease both ends of the cables and move the controls to end stop positions when lubricating. Re-attach the rubber covers on the cables after lubrication. Cables with sheaths will jam if they are not lubricated regularly. A jammed cable may cause malfunction, such as the parking braking being applied.

= Filter replacement

= Oil Change

= Level check

= Brush

= Grease nipple

= Oil can

Symbols on the lubrication chart

A. Radiator grille, See “Checking radiatorgrilles” on page 79.

B. Pump and alternator belt, See “Replacing the pump and generator drive belts” on page 81.

C. Power take-off belts, See “Replacing the power take-off belts” on page 105.

D. Coolant, See “Cooling system” on page 50.

E. Cutting unit belt, See “Replacing the cutting unit belt” on page 107.

F. Air filter, See “Servicing the air filter” on page 84.

G. Fuel filter, See “Servicing the fuel filter” on page 87.

53