Maintenance
2.Maintenance and replacement are required more often in dusty conditions.
3.With daily use, the machine shall be lubricated twice weekly.
4.Performed by authorised service workshop.
5.After the first 25 hours.
WARNING:
No service operations may be performed on the engine or cutting unit unless:
•The engine is stopped.
•The parking brake is on.
•The ignition key has been removed.
Cleaning
Clean the machine directly after use. It is much easier to wash off grass cuttings before they dry.
Oily dirt can be removed using a cold degreasing agent. Spray a thin layer and wait a few minutes.
Rinse at normal water pressure. Do not direct the jet towards electrical components or bearings.
Do not rinse hot surfaces, for example, the engine and exhaust system.
Clean the machine immediately after use
IMPORTANT INFORMATION:
Avoid using a high pressure washer or a steam cleaner.
Lubricate the machine if necessary after cleaning.
Carry out extra lubrication when the bearings have been exposed to a degreaser or a water jet. There is a major risk of water penetrating into bearings and electrical connections. Corrosion attack, which will lead to running problems. Cleaning additives generally aggravate the damage.
Check and clean if dirt collects in the area for the circuit card and on the circuit card. Clean using a dry method, i.e. with a vacuum cleaner or compressed air.
Do not blow directly on the circuit card. Do not rinse with water. There is a risk of damaging the circuit card.
37
