Husqvarna PT26 D manual Lift cylinder, Power take-off shaft’s front support bearing, Engine Oil

Lubrication

5. Lift cylinder

2 nipples, one at each end of the cylinder. Lubricate using a grease gun until grease is forced out.

Lift cylinder

6. The power take-off shaft’s front support bearing

Lubricate using a grease gun until grease is forced out.

The power take-off shaft’s front support bearing

7. Engine Oil

Viscosity and quality

Use engine oil viscosity as illustrated, class API CH4 or ACEA E5 or higher.

The engine holds 2.5 litres of oil excluding the filter (including filter 2.7 litres).

0W

5W 20

10W 30

15W 40

20W 50

20

30

40

-30	-20	-10	0	10	20	30	40	50 C
-22	-4	-14	32	50	68	86	104	122 F

Viscosity chart

Checking the oil level

Check the oil level in the engine when the machine is standing horizontally with the engine switched off.

Remove the dipstick and wipe it clean. Then insert the dipstick again.

Take the dipstick out again and read the oil level.

The engine dipstick

The oil level should be between the markings on the dipstick. If the level is approaching the “ADD” mark, lower notch, top up the oil to the “FULL” mark, upper notch on the dipstick.

55