Sensor I® Expert User Manual
To Tighten to a Torque
Set the torque value to your target torque, and set high and low torque and angle limits if desired. Snug is set automatically to a default value. This is the point from which the angle is activated. The default snug values for all models are listed in the TOLL DESCRIPTION Technical data table in Chapter
2.Reset the wrench before tightening. The OK light will go on and an alarm will sound when the target is reached. If the wrench is pulled too slowly for a long period (<10° per second for model 40, <5° per second for more than 5 seconds for all other models), the wrench will signal an error by sounding several short beeps.
To Tighten to an Angle
Set the snug torque and target angle as well as any high and low torque and angle limits. Reset the wrench before tightening. The Ok light will go on and an alarm will sound when the target is reached. If the wrench is pulled too slowly for a long period (<10° per second for 5 seconds for model 40, <5° per second for more than 5 seconds for all other models), the wrench will signal an error by sounding several short beeps.
To Tighten to Yield
Snug torque should be set to approximately 50% of the expected proof load torque of the bolt in use. Set any required torque or angle limits, and select your joint
