Sensor I® Expert User Manual
7. Audible Alarm
Signals the completion of a tightening procedure by continuous tone and signals a fault by an intermittent tone. The audible alarm will only sound while torque is being applied to the wrench handle.
8. Charger/Data Port
The battery charger inserts into this connector to charge the wrench. The serial port cable provided with the wrench also plugs into this connector. This port is located in the end of the handle for models 125, 250 and 400. For model 40, it is located on the rear of the Control Unit.
9. Toggle Lever
Selects the direction of the ratcheting mechanism; markings "ON" and "OFF" apply to
10. Power Switch
Located under the cap on the back of the wrench body (models 125, 250 and 400 not shown) or Control Unit (model 40), this switch turns power on and off to the wrench.
11. Angle Reference Arm Connector (EA-models)
Provides a fixed reference for angel measurement while operating the wrench. It is attached to the work piece by a magnet base and spring arm.
12
