Speco Technologies & IP-WDRB1 DIO Setting support for IP-INTT5/T5, IP-SD10X, Alarm Event Test

Speco Technologies IP Camera User’s Manual

4.5.2.Alarm Event Test

Click ‘Test’ of [4-18], THE CAMERA will work as if Alarm has happened. In case selected ‘Alarm

Style ->’Alarm Server’, Event is to be notified to Alarm Server and is to recorded into the

recorded file (10 seconds before and 50 seconds after Event), and to be sent to Alarm Server.

In case selected to use user FTP Server, the recorded file (10 seconds before and 50 seconds after Event) is to be saved in FTP Server. It may take some time for Alarm Message to get to user’s Mobile Phone or by E-mail, in some cases. If THE CAMERA has been registered in Service Server, it is available to check the details of Event and also change the Alarm Message of E-mail and Mobile Phone to be sent upon Event, in Alarm Server Homepage (Ipcam4u.net). Refer to ‘Use of Service Server’ in ‘ 5. Basic Use’ for details.

4.6.DIO Setting (support for IP-INTT5/T5, IP-SD10X)

Fig. 4―19 DIO Setting

Tick on sensor to use and select type of sensor to use.

￿Sensor Type : designate type of sensor, NC, NO. Designate name of sensor to use.

4 conditions are selectable for Relay. Relay name is to be input.

￿Disable: Relay is not active

41