Speco Technologies & IP-WDRB1, IP-INTT5 user manual Dynamic IP Setup, Check

Speco Technologies IP Camera User’s Manual

Fig. 3―6 IP Change loading Page

14)Remove LAN Cable (Cross Cable) connected between THE CAMERA and PC.

15)Connect THE CAMERA to Network with LAN Cable (Straight Cable).

16)Connect PC to Network with LAN Cable (Straight Cable)..

17)Set up IP Address, Subnet Mask and Gateway of PC according to the Network environment.

18)Check

￿Run Web Browser on PC, input IP address set in THE CAMERA onto URL and click ‘Enter’,

￿Check if IP Setting is correct or not, referring to ‘Video Check’

￿If Video is seen, THE CAMERA has been correctly set up.

￿If Video is not seen, check whether there may be a conflict of IP in the Network, and re-check the set value of Network environment of THE CAMERA, and Network environment of User’s PC.

3.2.2.Dynamic IP Setup

￿Do not set up Dynamic IP in the camera except as a direct connection of Cable Modem supporting Dynamic IP with the camera.

￿Reset, in case IP has not been allocated to THE CAMERA in Dynamic IP Setting, to go to Initial Value and try again.

1)After checking Video in ‘Video Check’, then go to the next step.

2)Connect THE CAMERA and LAN Cable (Cross Cable)

3)Cable Connection and Network Setting should be done same as per ‘2. Install and Video Check’.

23