Speco Technologies IP-INTT5, & IP-WDRB1 user manual ―7 Network Setting

Speco Technologies		IP Camera User’s Manual
4)	Go to Network Setting Page of Administrator’s Page as per 4), 5), 6), 7) of ‘Static
	IP Setup’.

Fig. 3―7 Network Setting

5)Click on ‘Dynamic IP Address’ in ‘IP Setting’.

6)Click ‘Save’ Button.

7)Upon completion of setting, close the Web Page and find IP of THE CAMERA in ‘IP Utility’

program provided with Proprietary Viewer (see ‘5. Basic Use’)

8)If the IP is found, THE CAMERA has been given an IP. But in case the IP is not found,

do a re-set of [2-1] to go to initial value because it has not been given an IP, then re-start the IP Setting. Once THE CAMERA has an IP, remove the LAN Cable (Crossover Cable) connected between THE CAMERA and the PC.

9)Connect THE CAMERA to the Network with LAN Cable (Straight Cable).

10)Connect PC to Network with LAN Cable (Straight Cable).

11)Set IP address of PC, Subnet Mask and Gateway properly according to the Network Environment.

12)Check

After registration of THE CAMERA in Service Server (refer to ‘Use of Service Server’ of ‘ 5. Basic Use’,

24