Ingersoll-Rand IRN100-200H-2S, IRN37-160K-CC manual Overhaul or replace, Check and modify settings

11.0 FAULT FINDING

SYMPTOM	FAULT	REMEDY
Compressor will not meet	Compressor not sized to	Contact your local IR representative
pressure required by system	meet system requirements or
	requirements have been changed.
	Air loss due to pipe, hose, joint or	Overhaul or replace
	seal failure
	Air loss due to blowdown valve stuck	Overhaul or replace
	open
	Air loss through pressure relief valve	Overhaul or replace
	not seating or set incorrectly
	Air loss due to moisture separator	Overhaul or replace
	drain trap stuck open
	Motor speed too low caused by drive	Contact your local IR representative
	incorrectly set
	Motor speed too low caused by fault	See section on drive faults
	in drive settings
	Intellysis controller fault	Overhaul or replace
	Drive motor fault	See section on drive faults
	Pressure transducer faulty,	Recalibrate or replace
	incorrectly calibrated or EMF
	interference
	Incorrect Intellisys controller settings	Check and modify settings
	Inlet grill or ducting is blocked	Check and clean
	Air filter dirty or collapsed	Replace
	Inlet valve not opening fully	Overhaul or replace
	Separator element dirty or collapsed	Replace
	Pipe / Hoses blocked or collapsed	Clean or replace
	Cooler core blocked	Clean or replace
	Minimum pressure check valve not	Overhaul or replace
	functioning correctly
	Equipment between compressor	Review system requirements
	and customer measuring point
	causing pressure drop / pressure loss

92IRN37 - 160K - CC & IRN50 - 200H -CC & IRN75 - 160K - 2S & IRN100 - 200H - 2S & IRN 250 - 300H - 2S

http://air.irco.com