Ingersoll-Rand IRN50-200H-CC, IRN37-160K-CC, IRN75-160K-2S Fault Cause Remedy, Pressure transducer

11.0 FAULT FINDING

FAULT	CAUSE	REMEDY
Remote start failure	Remote start button is pressed	Check operation of buttons or operating
	after machine is running or	procedures
	remote start button remains
	closed.
Remote stop failure	Remote stop button remains	Check operation of buttons or operating
	open and either start button is	procedures
	pressed
Sensor failure	Sensor is missing or faulty	Install, repair or replace faulty sensor
Compressor trips indicating a	Insufficient cooling taking place	If machine is watercooled or sea watercooled,
high compressor temperature.		check that the cooling water is flowing. Check
		that there is no air in the water cooling system.
		Check that the strainer is not blocked.
Intellisys controller has	A fault has occurred	Repair fault / reset Intellisys controller
tripped the compressor
Invalid Calibration	Calibration done with pressure	Depressurise and re calibrate with pressure pipe
	in compressor.	to sensor disconnected. If fault still exists, replace
		pressure transducer.
Low sump pressure	System leak	Located and repair
	Minimum pressure check valve	Repair with service kit
	faulty
	Blowdown valve faulty	Repair with service kit
	Loss of control power	Check 110V circuit breaker
		Check wiring
		Check contactor KM1
Check motor rotation	Drive system fault	Contact your local IR representative
VSD communication failure	Communication wiring faulty	Check and replace if required
	Drive faulty	Contact your local IR representative
	Intellisys faulty	Contact your local IR representative
VSD initialisation fault	Communication wiring faulty	Check and replace if required
	Drive faulty	Contact your local IR representative
	Intellisys faulty	Contact your local IR representative

IRN37 - 160K - CC & IRN50 - 200H & IRN75 - 160K - 2S & IRN - 100 - 200H - 2S & IRN 250 - 300H - 2S	95
http://air.irco.com