10 Intel Server Board SE7500WV2 Product Guide
Processor
The SE7500WV2 accommodates one or two Intel Xeon processors with 512k cache in the
INT3/FCPGA Socket 604 package. This processor uses the .13 micron technology. Check the
Intel Customer Support website for the latest list of supported processors see:
http://support.intel.com/
Memory
The system board has six 168-pin DIMM slots each supporting 72-bit ECC registered DDR
DIMMs (DDR-200 or DDR-266 compatible). Memory is partitioned in three banks. You may
install a minimum of 256 MB (128MB x 2) and as much as 12 GB. Memory must be installed in
pairs, starting with bank 1 (slots 1B and 1A).
The controller automatically detects, sizes, and initializes the memory array, depending on the type,
size, and speed of the installed DIMMs, and reports memory size and allocation to the server via
configuration registers.
NOTE
Use DIMMs that have been tested for compatibility with the server board.
Contact your sales representative or dealer for a current list of approved
memory modules. Check the Intel Customer Support website for the latest
tested memory list.
http://support.intel.com/
PCI Riser Slots
The server board has two PCI riser slots. Riser slot B provides the following features:
184 pin, 5 volt keyed, 64-bit expansion slot connector
Support for either a 1-slot or a 3-slot PCI riser card
Support for both full length and low profile PCI cards
Riser C provides the following features:
184 pin, 5 volt keyed, 64-bit expansion slot connector
Support for either a 1-slot or a 3-slot PCI riser card
Support for only low profile PCI cards
Video
The SE7500WV2 uses an ATI RAGE XL PCI graphics accelerator with 8 MB of video SDRAM.
The embedded SVGA video subsystem supports:
Resolutions up to 1600 x 1200 under 2D and 1024 x 768 under 3D
CRT and LCD monitors up to 100 Hz vertical refresh rate
The server board supports disabling of the onboard video through the BIOS setup menu or when a
plug in video card is installed in any of the PCI slots.