Intermec 751G user manual Installing and Charging the Battery

Chapter 1 — Using the Computer

If you have at least one device in your 751G (radio, scanner, or imager), the battery power fail level is set so that after the system shuts down in a low battery condition, there is still sufficient charge to allow the unit to remain configured, keep proper time, and maintain DRAM (Dynamic Random Access Memory) for at least 72 hours at room temperature if the main battery remains in the mobile computer.

The configuration and time are lost if:

•The battery discharges beyond this level.

•The battery is removed when the computer is not in suspend mode.

•A cold-boot (reset) is performed on the computer.

Installing and Charging the Battery

Make sure you fully charge the battery before you use your 751G. To charge the battery, you need to install it in the 751G.

1Remove the two thumb screws on the connector cover to release the hand strap and back cover.

2Slide the bottom of the strap forward to release it from the retaining slot.

Retaining slot

Thumb screws

3Tilt, insert, and place the battery into the compartment. Make sure the battery compartment latch clicks in place to ensure the battery is secure.

Battery compartment latch

Battery compartment

Battery pack

4Insert your 751G into its single dock for charging.

751G Color Mobile Computer User’s Manual 5