Intermec 751G user manual Removing the Battery, To remove the battery

Chapter 1 — Using the Computer

5Charge the battery pack for three hours before using. However, to ensure proper charging, perform the remaining steps first, with the AC adapter or dock connected:

a The first time you turn on your 751G, it boots to the operating system. After a few seconds, you see the Windows CE .NET Desktop screen. Tap your stylus to advance to the next display on the screen.

bYou will be prompted through the several screens to complete the setup process. Read the display messages and follow the instructions. When you reach the Windows CE .NET Desktop screen, you have completed the setup.

You must use only the Intermec power supply approved for use with the 751G. Using any other power supply will damage the 751G.

Note: For help installing and using the single dock, see the 700 Series Single

Dock Quick Start Guide (P/N 962-040-009) shipped with the dock.

Removing the Battery

Follow these instructions to remove the battery from the 751G.

Only use the battery compartment latch to dislodge and remove the battery. Using any other tool or method to remove the battery may damage the battery or the 751G.

Removing the main battery when the backup battery low or critically low icon appears on the status bar may cause your 751G to cold boot and you may lose data.

If you fail to replace the battery immediately, you may lose important data or applications.

To remove the battery

Pull up on the battery compartment latch, then lift the battery out of the battery compartment.

Battery compartment latch

Battery compartment

Battery pack

6 751G Color Mobile Computer User’s Manual