Intermec 751G Accessing the Secure Digital Card Slot, Internal Card Slots and Connector

Chapter 1 — Using the Computer

Accessing the Secure Digital Card Slot

To access the card slot, locate the access door at the top of the 751G, loosen its two screws, then remove the door. Note that the screws to this door are to be torqued to 1.5 in-lbs. See the Model 751G Mobile Computer Quick Start Guide (P/N 962-054-093) for more information.

Storage Media Access Door

This illustration shows the top of the 751G. Note the keypad is to the bottom.

Internal Card Slots and Connector

Below is a view of the various card slots within your 751G. Note that you only have access to the Secure Digital card slot. The other two slots are embedded into the unit and cannot be removed.

•A radio is embedded in the CompactFlash card slot and is not accessible.

•The Secure Digital card goes into the bottom left card slot.

•The SmartCard adapter plugs into the 6-pin connector in the bottom right.

CompactFlash card slot

Secure Digital card slot

6-pin connector

This illustration shows the top of the 751G. Note the keypad is to the bottom.

Attaching a Tab to the Secure Digital Card

The Secure Digital storage card, as ordered from Intermec, come with acrylic adhesive pull tabs. If you are using a storage card that you plan to remove from the 751G, this tab can make its removal easier.

Do the following to attach the tab to your storage card. Note that the pull tab has divots cut into either side, towards the shorter end. Use these divots as a guide.

1Completely peel the paper off the short end of the tab. Partially pull the paper off the long end of the tab away from the divots. Fold the short end under, at the divots, to stick to itself.

Long end of pull tab	Fold line at divots
	Short end of pull tab

16 751G Color Mobile Computer User’s Manual