Assigning Transport Controls
An Overview
The general procedure to change (edit) what a control sends or change its name, is to enter Assign Mode by pressing Assign. then do the following:
1.Select the control by moving it. This control is “held” in the LCD display, and you cannot at this point decide to edit a different control.
If you meant to edit a different control, press Assign twice to exit and
2.Make the desired edit, by turning the rotary encoders below the parameters shown the LCD.
3.Use the
4.To keep the changes, and store them to memory, press Enter on the Keypad.
5.You may then proceed to select another control to edit.
6.To discard the changes, do not press Enter. Simply press Assign to exit Assign mode.
7.When you are done editing, be sure that you have exited Assign mode. Yellow LED off.
51
