4. POWER SUPPLY

4-2 Battery Pack Operation (Optional) (Cont’d)

Using a Flat Shape Type Battery Pack (optional)

Attaching a Flat Shape Type Battery Pack

1. Open the battery case cover while pushing the lock release

 

lever.

 

2. Insert the battery pack into the battery case with its

 

electrodes facing the unit.

 

3. Close the battery case cover.

Lock release

Be sure to set the POWER switch to OFF before replacing

lever

the battery pack.

4. POWER SUPPLY

Using an Anton-Bauer Battery Pack

To use an Anton-Bauer battery pack (Propack 13/14, Trimpack 13/14, Magnum 13/14, Compack 13/14 Series), it is necessary to detach the battery case from the GY-DV5000 and replace it with the Anton-Bauer battery holder. Use the following battery holder. • Battery holder: Anton-Bauer QRQ27

Detaching the Battery Case From the GY-DV5000 and Attaching The Anton- Bauer Battery Attaching the Anton-Bauer Battery Holder Anton-Bauer Battery Holder

2.

1. Black screw A

1. Remove the two black screws A on the battery case.

2. Remove the lower half of the battery case cover in the downward direction.

3.Connector

3.Mount screw B

3.Mount screw B

3. To remove the battery case, remove the four screws Bfixing the battery case and the connector connecting the battery case to this unit.

4.

5.

5.

Anton-Bauer

Connector

 

 

 

 

Battery holder

Compartment

4. Connect the connectors protruding from the GY-DV5000

 

with the connectors on the battery holder.

 

 

 

 

CAUTION:

 

 

Following connection of the connectors, insert them into

the connector compartment.

 

Take care not to pinch the wires. This could result in

damage.

 

5. Secure the battery holder to the GY-DV5000 with the four

 

mount screws provided with the battery holder.

Attaching and Detaching an Anton-Bauer Battery Pack

Guide pins

 

Cassette cover side panel

Battery pack

Guide holes

(Trimpack)

 

(x3)

 

Release

Release lever

 

lever

 

Side panel

Battery

with display

Attaching the Battery Pack

1. Align the 3 guide pins of the battery pack with the guide holes on the battery holder, and push straight to insert the battery pack. The battery cannot be attached properly if the guide pins are not inserted straight.

2. Slide the battery pack toward the side panel where the cassette cover is located until it clicks. Now the battery pack has been attached.

Detaching the Battery Pack

While pushing the release lever, slide the battery pack toward the side panel where the LCD display is located, then pull the battery pack outward to remove.

34

35

Page 19
Image 19
JVC GY-DV5000 Battery Pack Operation Optional Cont’d, Using an Anton-Bauer Battery Pack, Attaching the Battery Pack