Attaching a Flat Shape Type Battery Pack
Lock release lever
E-36
Using a

U

4. POWER SUPPLY

4-2 Battery Pack Operation (Optional) (Cont’d)

Attaching and Detaching an Anton-Bauer Battery Pack

E

4. POWER SUPPLY

4-2 Battery Pack Operation (Optional) (Cont’d)

Flat Shape Type Battery Pack (optional)

Guide pins

 

Cassette cover side panel

Battery pack

Guide holes

 

(x3)

 

Release

Release lever

lever

 

Side panel

Battery

with display

Attaching the Battery Pack

1.Align the 3 guide pins of the battery pack with the guide holes on the battery holder, and push straight to insert the battery pack.

The battery cannot be attached properly if the guide pins are not inserted straight.

2.Slide the battery pack toward the side panel where the cassette cover is located until it clicks. Now the battery pack has been attached.

Detaching the Battery Pack

While pushing the release lever, slide the battery pack toward the side panel where the LCD display is located, then pull the battery pack outward to remove.

1. Open the battery case cover while pushing the lock release lever.

2. Insert the battery pack into the battery case with its electrodes facing the unit.

3. Close the battery case cover.

Be sure to set the POWER switch to OFF before replacing the battery pack.

Attaching the NP-1B type Battery

To use the NP-1 type battery, remove the Anton-Bauer Battery holder and attach the NP-1 type battery holder to the camera. Use the following battery case.

Battery case: SCV2978-002

For details, please consult your JVC authorized dealer.

Detaching the Anton-Bauer Battery Holder and Attaching the Battery Case

Be careful of pins.

2.

1.

1.

Anton-Bauer

Connector

Compartment

Battery holder

 

4.

CAUTION:

The Anton-Bauer Battery Holder has pin connectors. Be careful not to touch these pin terminals when attaching or removing the battery and holder. Doing so may cause injury.

1.Remove the four battery holder anchoring screws.

2.Disconnect the connector and battery holder connector coming out of the camera.

3.Remove the two black screws A for the battery case.

4.Remove the bottom portion of the battery case cover downwards.

3.Black screws A

36

Page 28
Image 28
JVC GY-DV5100 Battery Pack Operation Optional Cont’d, Attaching the NP-1B type Battery, Attaching the Battery Pack