JVC GY-DV5100 Using an Anton-Bauer Battery Pack, Attaching a Flat Shape Type Battery Pack

U

E

	4. POWER SUPPLY
5. Connector	5. Connect the connector and battery holder connector coming
6. Mount screws B	out of the camera.
	CAUTION:
	Following connection of the connectors, insert them into
	the connector compartment.
	Take care not to pinch the wires. This could result in
	damage.
	6. Attach the battery case with the four mount screws B.

4. POWER SUPPLY

Using an Anton-Bauer Battery Pack

To use an Anton-Bauer battery pack (DIONIC 90, Propack 13/14, Trimpack 13/14, Magnum 13/14, Compack 13/14 Series), it is necessary to detach the battery case from the GY-DV5100 and replace it with the Anton-Bauer battery holder. Use the following battery holder.

• Battery holder: Anton-Bauer QR JVC DIGI

Detaching the Battery Case From the GY-DV5100 and Attaching The Anton-

Bauer Battery	Attaching the Anton-Bauer Battery Holder
	Be careful of pins.

6.Mount screws B

Wire layout

2.

4.

7.

CAUTION:

Mount screws B use M3 ⋅ 6 mm screws.

7. Attach the battery case cover.

8. Attach the two battery case black screws A.

1.Black screw A

1.Remove the two black screws A on the battery case.

2.Remove the lower half of the battery case cover in the downward direction.

3.Connector

3.Mount screw B

5.

5.
	Wire layout
Anton-Bauer
	Connector
Battery holder	Compartment

4. Connect the 2 connectors protruding from the battery holder

8.Black screws A

Using a Flat Shape Type Battery Pack (optional)

to the connectors on the camera.

CAUTION:

● Following connection of the connectors, insert them into

the connector compartment.

Attaching a Flat Shape Type Battery Pack

1.Open the battery case cover while pushing the lock release lever.

2.Insert the battery pack into the battery case with its electrodes facing the unit.

3.Close the battery case cover.

3.Mount screw B

3.To remove the battery case, remove the four screws Bfixing the battery case and the connector connecting the battery case to this unit.

Take care not to pinch the wires. This could result in

damage.

● The Anton-Bauer Battery Holder has pin connectors. Be

careful not to touch these pin terminals when attaching

or removing the battery and holder. Doing so may cause

injury.

5. Secure the battery holder to the GY-DV5100 with the four

mount screws provided with the battery holder.

Lock release lever

Be sure to set the POWER switch to OFF before replacing the battery pack.

Attaching and Detaching an Anton-Bauer Battery Pack

Guide pins
Cassette cover side panel	Battery pack
Guide holes
(⋅3)
Release	Release lever
lever

Side panel	Battery
with display

Attaching the Battery Pack

1.Align the 3 guide pins of the battery pack with the guide holes on the battery holder, and push straight to insert the battery pack.

The battery cannot be attached properly if the guide pins are not inserted straight.

2.Slide the battery pack toward the side panel where the cassette cover is located until it clicks. Now the battery pack has been attached.

Detaching the Battery Pack

■While pushing the release lever, slide the battery pack toward the side panel where the LCD display is located, then pull the battery pack outward to remove.

37 E-37