Cleaning the Shuttle Race

This area must be kept free of dust, lint and tangled thread.
Clean the shuttle race area every three months.
Cleaning the shuttle area
_1_Bobbin case
,(2_Levers
,_3_Shuttle race cover
'_4_Shuttle
,_5_Shuttle race
,(6_:Center pin on the shuttle
1. Raise the needle bar to its highest point, then and
remove the bobbin case _1_.
2. Push the shuttle race levers _2_aside. Lift outthe shuttle
race cover _3_and take the shuttle _4_out.
3. Clean the shuttle race _5_with a lint brush.
4. Put a drop ofoil on the center pinof the shuttle _ and
the shuttle race _5_.Do not over oil.
Replacing shuttle assembly
_2_Levers
_3_Shuttle race cover
_4_Shuttle
_5_Shuttle race
_ Center pin on the shuttle
_7_Shuttle driver
'_8_Pointed hook
@ (Oil here)
1. Turn the handwheel so the shuttle driver _7_forms a
half moon on the left side of the machine.
2. Hold the shuttle @ by its center pin _6_,and position the
shuttle so itforms a half moon onthe right side. The
hook_8_will be on the bottom.
3. Put the shuttle race cover _3_back into place over the
shuttle assembly.
4. Snap the levers _2_back into the original position.
f
\\
................... f6b
J
J
74