Kenmore 385.12314 DANG ER- To reduce the risk ofelectric shock:

Your sewing machine isdesigned and constructed only for HOUSEHOLD use

Read alt instructionsbefore using this sewing machine1.

DANG ER- To reduce the risk ofelectric shock:

1. This sewing machine should never be leftunattended when plugged in Always unplug this sewing machine from the

electric outlet immediately after using and before cleaning°

2. Always unplu_ before replacing a sewing machine bulbo Replace bulb with same type rated 15 Watts_

3. Do not reach for a sewing machine that has fallen into water° Unplug immediately..

4_ Do not place or store this sewing machine where it can fail or be pulled into a tub or sink. Do not place or drop it into water

or other liquid.

WAR N!NG - Toreduce the risk of burns, fire, electric shock, or injury to persons:

1_ De not allow this sewing machine to be used as a toy°Close attention isnecessary when this sewing machine is used by

or near children..

2. Use this sewing machine only for its intended use as described in this owner's manual,.

Use only attachments recommended by the manufacturer as contained in this owner's manual.

3 Never operate this sewing machine ff it has a damaged cord or plug, ff it is not working properly, if it has been dropped

or damaged, or dropped into water..

Return this sewing machine to the nearest Sears store or service center for examination, repair, electrical or mechanical

adjustment,

4. Never operate this sewing machine with any air opening blocked. Keep ventilation openings of this sewing machine and

foot controller free from accumulation of lint, dust and loose cloth.

5. Never drop or insert any object into any opening.

6° Do not use outdoors.

7. Do not operate where aerosol (spray) products are being used or where oxygen is being administered

8. To disconnect, turn all controls tothe off ("0") position, then remove plug from outleL

9.. Do not unplug by pulling on cord° To unplug, grasp the plug, not the cord

10,.Keep fingers away from all moving parts. Special care is required around the sewing machine needle,

11,Always use the proper needle plate_ The wrong plate can cause the needle to break.

12,Do not use bent needles.

!3. Do net pull or push fabric while stitching. It may deflect the needle causing itto break.

14_Switch this sewing machine off ("0") when making any adjustment in the needle area, such as threading the needle,

changing the needle, threading the bobbin or changing the presser foot, and the like,

15_Always unplug this sewing machine from the electrical outlet when removing covers, lubricating, or when making any

other adjustments mentioned in this owner's manual..

When usingyour sewing machine for the first few times, place a waste fabric under the presser foot and run I

the machine without thread for a few minutes Wipe away any oil which may appear_