!7Works as an S-meter in the receive mode. Works as the meter you selected while transmitting.

!8“” appears when the internal TNC is assigned to the main transceiver.

!9The Hz digits of the main transceiver operating frequency appears.

@0Appears when the frequency point of Program Scan Partially Slowed is selected on the main transceiver.

@1When the sub-receiver is switched ON, it shows the operating frequency for the sub-receiver. However, if you are controlling the main transceiver functions, such as RIT, XIT or SPLIT, it displays the frequency information for these functions.

@2Serves as an S-meter for the sub-receiver. It also displays the relative output power when the sub-band is selected for transmission.

@3Appears when the MHz Up/ Down mode is selected.

@4Appears when the Fine tuning function is selected.

@5“PKT” appears when the internal TNC is operating in Packet mode.

@6“tM” or “Ms” appears while a simplex memory channel is selected. “tMs” appears while a split frequency memory channel is selected.

@7“tB” or “Bs” appears while VFO B is selected. “B” appears while Menu B is being accessed.

@8“tA” or “As” appears while VFO A is selected. “A” appears while Menu A is being accessed.

@9“DSP” appears when one of the DSP functions is activated.

#0“AGC” appears when the AGC function is ON. “R” (Reverse function), “[R]” (Automatic Simplex Check), or the Repeater shift direction (“–”, “+”, or “=”) appears.

Note: “=” appears only for E-types.

#1“ATT” appears when the attenuator function is ON. “PRE” appears when the preamplifier function is ON. “P/A” appears when both functions are ON.

#2“RtEQ” appears when the RX Equalizer function of the main transceiver is ON. “EQsT” appears when the TX equalizer function is ON.

#3“EXT” appears while the HF RX ANT connector is enabled to receive HF band signals.

#4“NB” appears when the Noise Blanker function is ON.

#5“A” appears when Auto mode selection is activated.

#6The current operating mode for the main transceiver appears.

#7“PROC” appears when the Speech Processor function is ON.

#8“PTT” appears when the main transceiver is selected for the transmission band. “Ctrl” appears when the main transceiver is selected for the Control band.

#9“VOX” appears when the VOX function is ON.

11