SKY COMMAND II+ (K-TYPE ONLY)

The Sky Command II+ allows you to remotely control a TS-570, TS-870, or TS-2000 series HF transceiver from a separate location. Before operating Sky Command II+ with the RC-2000, read the Sky Command II+ section of the TS-2000(X)/ TS-B2000 instruction manual, starting on page 83. After completing the setup, refer to pages

84~ 88 of the TS-2000(X)/ TS-B2000 instruction manual for the control operations using a TM-D700A, TH-D7A, or another TS-2000(X) transceiver.

PROGRAMMING CALL SIGNS

The TS-2000(X)/ TS-B2000 can serve as either Commander or Transporter. Program the same callsign for both Commander and Transporter. Refer to page 83 of the TS-2000/ TS-B2000 instruction manual for the possible callsign entries.

On the TRANSPORTER:

1Press [F1] (1 s) until you select group A.

2Press [F1] until you select A–3.

3Press [MENU].

4Turn the MULTI/ CH control to select Menu No. 62.

5Press [SUB].

6Turn the MULTI/ CH control to select Menu No. 62A.

7Press [OK].

• The Commander callsign entry prompt appears.

8Turn the Tuning control to select a character.

• You can enter 0 to 9, A to Z, and –.

9Press [b]/ [a] to move the cursor. Press [DEL] to delete the character at the cursor. Press [CLR] to cancel the entry.

10Press [OK] to store the callsign.

On the COMMANDER:

1Press [F1] (1 s) until you select group A.

2Press [F1] until you select A–3.

3Press [MENU].

4Turn the MULTI/ CH control to select Menu No. 62.

5Press [SUB].

6Turn the MULTI/ CH control to select Menu No. 62B.

7Press [OK].

•The Transporter callsign entry prompt appears.

8Turn the Tuning control to select a character.

•You can enter 0 to 9, A to Z, and –.

9Press [b]/ [a] to move the cursor. Press [DEL] to delete the character at the cursor. Press [CLR] to cancel the entry.

•The callsign must match the Transporter callsign to perform Sky Command II+ operation.

10Press [OK] to store the callsign.

44