PROGRAMMING A TONE FREQUENCY

You must also program the CTCSS tone to operate the Sky Command II+. Select the same CTCSS tone for both the Commander and the Transporter.

1Press [F1] (1 s) until you select group A.

2Press [F1] until you select A–3.

3Press [MENU].

4Turn the MULTI/ CH control to select Menu No. 62.

5Press [SUB].

6Turn the MULTI/ CH control to select Menu No. 62C.

7Press [–/] [+] to select a CTCSS tone frequency for the Sky Command II+ operation.

8Press [OK] to store the CTCSS tone frequency for the Sky Command II+ operation. Press [CLR] to cancel the selection.

PROGRAMMING COMMUNICATION SPEED

You must configure the same TNC communication speed between the Commander and the Transporter.

1Press [F1] (1 s) until you select group A.

2Press [F1] until you select A–3.

3Press [MENU].

4Turn the MULTI/ CH control to select Menu No. 62.

5Press [SUB].

6Turn the MULTI/ CH control to select Menu No. 62D.

7Press [–/] [+] to select either 1200 bps or 9600 bps.

8Press [OK] to store the TNC communication speed for the Sky Command II+ operation. Press [CLR] to cancel the selection.

Note: 9600 bps can be used only when you use TS-2000(X)/ TS-B2000 for both the Commander and the Transporter.

CONFIGURING A TNC BAND

If you are using a TS-2000(X)/ TS-B2000, confirm that the built-in TNC is assigned to the sub-receiver.

1Press [F1] (1 s) until you select group A.

2Press [F1] until you select A–3.

3Press [MENU].

4Turn the MULTI/ CH control to select Menu No. 46.

5Press [–/] [+] to select “SUB”.

6Press [OK] to store the TNC band for the Sky Command II+ operation. Press [CLR] to cancel the selection.

45