STARTING SKY COMMAND II+ OPERATION

1Select an open 144 MHz frequency on the main transceiver.

2Select an open 440 MHz frequency for the sub- receiver.

3Press [F1] (1 s) until you select group A.

4Press [F1] until you select A–3.

5Press [MENU].

6Turn the MULTI/ CH control to select Menu No. 62.

7Press [SUB].

8Turn the MULTI/ CH control to select Menu No. 62E.

9Press [–/] [+] to select either “COMMAND” (Commander) or “T-PORTER” (Transporter).

10The Sky Command II+ operation starts.

Note: “CLIENT” is used when you use another TM-D700A or TH-D7A for the Transporter of the Sky Command operation. Refer to “USING A SEPARATE TRANSPORTER” {TS-2000 page 88}.

TO EXIT SKY COMMAND II+ OPERATION

1Press [MENU].

2Press [–/] [+] and select “OFF” to exit the Sky Command II+ operation.

46