FRONT PANEL INSTALLATION

1Assemble the mounting brackets using the 2 supplied hexagon SEMS screws and the 2 flat washers.

• Do not completely tighten the screws in this step.

SEMS screw

4 mm x 10 mm

2Peel off the paper backing from the base of the bracket.

3Position the bracket in the vehicle, then install it securely using the 3 supplied self-tapping screws and

the 3 flat washers.

Self-tapping screw

Flat washer

4 mm x 14 mm

4Align the grooves on the front panel over the bracket tabs.

Bracket tab

5Slide the front panel down until it locks in place.

•The tab on the front panel must be completely locked by the bracket otherwise vehicle vibration may cause the front panel to become dislodged.

Locking tab

6Position the front panel at your desired angle, then completely tighten the 2 SEMS screws on the bracket.

SEMS screw

3