USING VISUAL SCAN
1Select your desired frequency using the Tuning control.
2Turn the Tuning control or press Mic [UP]/ [DWN] to select the operating frequency.
•This frequency will be used as the center frequency for the Visual Scan.
3Press [F1] (1 s) until you select group B.
4Press [F1] until you select
5Press [VISUAL] to start the Visual Scan.
•To pause the Scan, press [PAUSE]. “P” appears on the display. Press [PAUSE] again to resume scanning.
6To change the center frequency, turn the Tuning control or press Mic [UP]/ [DWN].
•The displayed frequency changes and the cursor moves.
•Press [SET] to use the changed operating frequency as the center frequency.
•Press [RESET] to restore the original center frequency.
7To quit Visual Scan, press [EXIT].
Note:
◆You can press the Tuning control to change the Tuning control and MULTI/ CH control to adjust the operating frequency. “TUN” or “MLTI” appears to indicate which control mode is selected.
◆If you start Visual Scan in Memory Recall mode, the memory channel frequencies will be scanned.
◆Visual Scan stops while transmitting.
◆During the Visual Scan, the scanning frequency cannot be monitored through the speaker.
◆Depending on conditions, Visual Scan and the conventional
40