PREPARATION

INSTALLATION

Install the bracket securely onto the vehicle, using 6 sets of the supplied screws (N99-2024-XX).

When using the RC-2000 in your vehicle, you can install the transceiver in the trunk, under the seat or under the dash board. On the transceiver, install the DC cable

Flat washer

Spring washer

Bracket

(7 m/ 23.1 ft), the microphone extension cable

(5 m/ 16.5 ft), a cable for the speaker (5 m/ 16.5 ft), a cable to the RC-2000 (5 m/ 16.5 ft), and coaxial cable(s) to the antenna (not supplied in this package). Make sure all cable lengths are adequate before installing the brackets.

TRANSCEIVER INSTALLATION

When installing the metal plates, first attach the plastic spacers (G11-2698-XX) to the transceiver. This is necessary to protect the TS-2000(X)/ TS-B2000 from scratches.

Note: The plastic spacers (G11-2698-XX) are supplied accessories for the TS-2000(X)/ TS-B2000 transceiver.

Spacers (G11-2698-XX)

3 mm x 4 mm

Vehicle chassis

Nut

6 mm x 20 mm

Then, prepare the transceiver by loosely screwing in the rear screws. Hook those screws onto the rear guide rail of the mounting bracket, then adjust the transceiver to your desired angle before tightening the screws. Insert and tighten the front screws to secure the transceiver in place.

Rear screws

4 mm x 10 mm

Front screws

To remove the transceiver from the bracket, first remove the front screws, then loosen the rear screws slightly and pull the transceiver forward to unlatch it from the bracket.

The tab faces out

The tab faces out

Do not install the transceiver so that it is vertically on its side.

 

 

 

2