LIST FUNCTION IN P.C.T. MODE

To access your desired DX information from the P.C.T memory in the P.C.T. mode:

1Press [LIST] (L2).

2Press [c]/ [d] or turn the MULTI/ CH control to select the report.

•“s” indicates which DX report is currently selected.

3Press [SET] to tune the main transceiver to the reported frequency.

•Press [DEL] to erase the selected DX information from the P.C.T. memory. Press [EXIT] to return to normal P.C.T. information display.

•Press [OK] to view all the comments of the selected DX station.

NEW PACKET CLUSTER DATA

The transceiver can be set to output a beep instead of a Morse code when new DX Packet Cluster data is received. Press [MENU] while in group A–3, then turn the MULTI/ CH control to select Menu No. 49. Press [SUB], then turn the MULTI/ CH control to access Menu No. 49B. Select “OFF”. “VOICE” can also be set when you install the optional VS-3 {TS-2000 page 91}.

Note:

◆You cannot send DX information to a node using the P.C.T. mode.

◆The DX Packet Cluster data in memory is retained when the transceiver is turned OFF. However, the sub-receiver’s frequency display returns to the receiving frequency of the DX Packet Cluster node.

38