GROUP C–2

VOX

Press to switch the CW break-in function ON or OFF.

BK DLY

Press to adjust the CW break-in delay time {TS-2000 page 42}. Select your desired break-in delay time using the [c]/ [d] keys or by turning the MULTI/ CH control, then press either [EXIT] or the MULTI/ CH control to change the setting. The values range from FBK (full break-in) to 100 which is the slowest delay time.

KEY

Press to adjust the keying speed of the electric keyer. Select your desired keying speed using the [c]/ [d] keys or by turning the MULTI/ CH control, then press either [EXIT] or MULTI/ CH control to change the setting. The adjustable keying speed is between 10 (WPM) and 60 (WPM).

RF

Press to adjust the Radio Frequency (RF) gain for the main transceiver. Select your desired RF gain value using the [c]/ [d] keys or by turning the MULTI/ CH control, then press either [EXIT] or the MULTI/ CH control to change the setting. The minimum RF gain value is 0 and the maximum value is 255.

GROUP C–3

N.R.

Refer to N.R. in the USB/ LSB section {page 22}.

M.B.C.

Press to switch the Manual Beat Cancel function ON or OFF. Press and hold the key to enter the manual beat cancel frequency adjustment mode. Adjust the beat cancel frequency using the [c]/ [d] keys or by turning the MULTI/ CH control, then press either [EXIT] or the MULTI/ CH control to store the setting.

FILTER

USB/ LSB/ FM/ AM mode:

Press to adjust the low cut-off or high cut-off frequency of the DSP. Press [HI] or [LOW] to select the high or low cut-off, then press [c]/ [d] or turn the MULTI/ CH control to select the desired cut-off frequency. Press [EXIT] or MULTI/ CH control to accept the new setting.

CW/ FSK mode:

Press to adjust the DSP filter width or shift frequency. Press [SFT] to adjust the shift frequency, then press [c]/ [d] or turn the MULTI/ CH control to select the desired shift frequency. Press [EXIT] to accept the new setting. Press [WID] to adjust the filter width, then press [c]/ [d] or turn the MULTI/ CH control to select the desired shift frequency. Press [EXIT] or MULTI/ CH control to accept the new setting.

24