
APPENDIX
RESETTING MEMORY DATA
You can reset the stored memory data to the factory default values if necessary. By performing the reset, you will lose all the relative contents of memory data. So, we recommend you write down any important memory data before performing the reset. To perform the reset, first switch the transceiver OFF.
|
| Instruction | Function | |
Press | Resets the contents of PM | |||
[R1]+ | (Programmable Memory) to the | |||
[ |
| ] (POWER) | factory default values {page 42}. | |
| ||||
| ||||
|
|
|
| |
Press | Performs a Partial Reset | |||
[L2]+ | ||||
[ |
| ] (POWER) | ||
| ||||
|
|
Press
1Press [F1]+[ ] (POWER) on the
2To exit the demonstration mode, first turn the
transceiver OFF, then press [F1]+[ ] (POWER) on the
Note: You cannot exit the demonstration mode by simply switching the transceiver OFF or performing a full reset
CONFIGURING THE AUTO MODE FREQUENCY TABLE
To configure the Auto Mode frequency table:
1 | Press [F6]+[ |
| ] (POWER) on the |
| |||
| the transceiver ON. | ||
2 | Use the following controls to configure the table. | ||
| Tuning control: Adjust the frequency |
[L3]+
Performs a Full Reset
MULTI/ CH control: Change the channel number |
[MODE]/ [REV]: Change the operating mode |
[ ] (POWER)
When a confirmation message appears, press [OK] to proceed. Otherwise, press any other key to cancel the operation.
DEMONSTRATION MODE
The
[UP]/ [DWN]/ [1MHz]: Change the operating band |
3 Press [OK] to store the settings. |
CONCERNING THE TM-D700A/E PANEL
The ] (POWER). The
54