Getting Started

USING THE BELT LIFTER (cont)

To use the Belt Lifter, you must first raise the Headlight

1Hood (21). >

2Flip out the handle on the Belt Lifter (20). Use it to turn the Belt Lifter fully to the left (counter-clockwise) until it stops and the red arrows line up. This stretches the

belt and lifts it off the motor shaft. Return the handle on the Belt Lifter to its closed position.

If you are using your Sentria™ system as a straight suction cleaner, simply lower the Headlight Hood. The Brush Roll is now disengaged and will not rotate when the power switch is turned ON. >

3The belt will be stretched to the top of the nozzle as shown. >

To re-engage the belt so the Brush Roll rotates, simply

4 raise the Headlight Hood and use the handle to turn the Belt Lifter fully to the right (clockwise) until the green arrows line up. Then lower the Headlight Hood.

The Brash Roll will now rotate when the Power Switch is turned ON.

NOTE: The belt should not be stretched when stored for an extended period. Make sure the green arrows line up for storage. >

Your Sentria system is equipped with a Brush Roll

5 Performance Indicator Light (7), located on the top right side of the Power Nozzle. The purpose of this light is to show if the Brush Roll is rotating properly.

If the Brush Roll Indicator Light flashes intermittently or does not come on when using the Power Nozzle, the Brush Roll Belt may not be working properly. Either the Belt is not engaged or may need to be replaced.

To replace the Brush Roll Belt, also called the Power Nozzle

Belt, see Page 55. •

11