
Canister Cleaner & Attachments
CONVERTING TO A CANISTER CLEANER/
INSTALLING THE ATTACHMENT HOSE
When using different cleaning attachments, the Attachment
Hose is connected to the front of the cleaner in place of the
Power Nozzle (25).
NOTE: When connecting the Attachment Hose, you may choose between the Upright Handle (17) or the Portable Handle (15). To install the Portable Handle, see page 16.
To install the Attachment Hose, you must first convert
1to a Canister by removing the Power Nozzle. To do so, press the
way down until nozzle is fully raised. Disengage Tech Drive® power assist by stepping on the gray "N" side (marked "N" for Neutral) of the Tech Drive N/D Pedal (11). Turn the Sentria™ system OFF by pressing the Power Switch (13) and then unplugging. >
Raise the Headlight Hood (21) and flip out the handle
2 on the Belt Lifter (20). Use it to turn the Belt Lifter all the way to the left
Unlock the Power Nozzle by turning the Accessory Lock
3(22) all the way to the left
At the connector end of the Attachment Hose, you will
4 notice two hooks. Place the hooks over the ends of the Attaching Bar (24), then push the opening of the hose up against the Sentria system. >
5Lock the Attachment Hose Connector in place by turning the Accessory Lock (22) all the way to the right (clockwise). (Accessory Lock will clamp the
Attachment Hose to the unit.)
With the Attachment Hose in place, the unit will automatically adjust to high speed for hose operation.
NOTE: If the Sentria system will not run when the Power
Switch is ON, see page 59. •
|
| In normal operation, friction between the belt and the metal motor |
| /!\ CAUTION: | |
| shaft may cause the metal motor shaft to become hot to the touch. | |
|
| |
|
|
|
19