Optional Accessories

PROTECTING YOUR CARPET (cont)

If Kirby Guard has been sprayed onto any hard sur-

4 faces such as furniture, baseboards, tile, etc., wipe off before drying occurs. Allow carpets to dry thoroughly before resuming normal use. >

5 Thoroughly clean the Portable Sprayer after use. •

USING THE KIRBY MIRACLE WAXER®FLOOR POLISHER

1To assemble the roller waxer applicator, attach the top half of the roller waxer handle to the bottom half (if not already done). Adjust the upper half until the spring-

loaded pin in the lower half is seated in the hole near the bottom of the upper half. >

KIRBY MIRACLE WAX DIRECTIONS

For Hardwood, Vinyl, Cork and Linoleum Floors:

1.Clean surface thoroughly.

2.Attach Kirby Floor Care System Buffer Nozzle and Brush according to the instructions on page 39, under "Floor Buffer Set-Up."

3.For best results, apply a very thin coat of Kirby Miracle Wax using the roller applicator. It is not necessary to completely cover the floor with wax at this time, as the wax will be spread in the next step.

4.Using the Toe-Touch Control Upper Pedal to lower the nozzle all the way down, spread the wax evenly over the entire floor using the Kirby Floor Care System Buffer Brush.

5.Let dry 5 minutes.

6.When dry, buff with the Kirby Floor Care System Buffer Brush.

NOTE: For very worn areas, two coats may be required. In this case, multiple thin coats will provide better results than one thick coat.

For Marble Floors:

Apply a thin coat and spread as in the directions in #4. However, buff immediately, avoiding any drying time.

Once you have completed the steps above, the floor may be rebuffed, any time it becomes necessary, using the Floor Care System Buffer Brush. Apply additional wax ONLY when rebuffing does not produce acceptable results.

IMPORTANT:

Do not use Kirby Miracle Wax on rubber or asphalt tile. •

37