Optional Accessories

CLEANING THE CARPET SHAMPOO

SYSTEM (cont)

To remove the Shampoo Tank from the Air Exhaust

8Port (19), rotate it away from the Sentria™ system as far as it will go, then lift it upwards. >

Remove and clean the Suds Screen Cap, Cup and

9 Sponge Filter.

Rinse out the Shampoo Tank with cold water and replace the Screen Cap, Cup and Sponge Filter.

NOTE: The belt should not be stretched for extended periods. Make sure the green arrows on the nozzle line up for storage. (Remember to align the red arrows before replacing the nozzle on the unit - see Belt Lifter section on page 10.) •

REPLACING A WORN CARPET SHAMPOOSYSTEM NOZZLE BELT

To replace the Carpet Shampoo System Nozzle Belt,

1push the thumb pads located at each end of the shield and rotate the shield up and away from the brush. >

Push down carefully on the ends of the brush with

2 your thumbs. The brush will snap out and the belt can be replaced.

Be certain the belt is placed in the center of the brush.

NOTE: Use only approved Kirby® belts. >

35