Getting Started

POWER NOZZLE HEIGHT ADJUSTMENT

When using the Power Nozzle (25), it is important to adjust the height properly. Start by pressing the Toe-Touch Control Bottom Pedal (9) all the way down, raising the front of your system all the way up.

The Toe-Touch Control adjusts the Power Nozzle to seven different heights. The highest four positions are used for attaching accessories. Positions #1-3 are used for carpet and floor cleaning. Positions #1-3 are indicated when the number shows directly in front of the Toe-Touch Control Upper Pedal (8).

Turn the unit on and press the Toe-Touch Control upper pedal 4 times (one notch at a time) until you see the #3 in front of the Toe-Touch Control Upper Pedal. You are now at the HIGHEST floor cleaning position used for high-pile and plush carpets.

Press one more notch down for the MEDIUM position (until you see the #2 in front of the Toe-Touch Control Upper Pedal.) This is the most widely used position for all-type carpets. Push one more notch down for LOW (until you see the #1 in front of the Toe-Touch Control upper pedal). This is the lowest position for low pile carpet and hard floor cleaning.

NOTE: When finished vacuuming, press the Toe-Touch

Control Bottom Pedal all the way down to move your

Sentria system. •

TECH DRIVE® POWER ASSIST

Your new Sentria system is equipped with Tech Drive power assist. This innovative feature eliminates most of the effort required to move your Sentria system back and forth. •

TURNING TECH DRIVE POWER ASSISTON (DRIVE)

To engage Tech Drive power assist push down the red "D" side (marked "D" for Drive) of the Tech Drive N/D Pedal (12) located just below the Power Switch. (13)

You may use your Sentria system without Tech Drive power assist if desired. Simply put the Tech Drive pedal in Neutral. •

 

 

To avoid possible damage to soft tiles or marking of waxed and

 

/!\ IMPORTANT:

 

finished non-carpeted floors, disengage the Tech Drive pedal.

 

 

 

 

 

8