Lenovo TD230 manual Completing the parts replacement, Installing the server cover

10.Properly route the power cables through the holes 1 in the chassis and connect the power cables to all drives, PCI card(s) if necessary, and the system board. Then, secure the power cables to the chassis with cable clips or ties, if necessary.

Figure 85. Holes in the chassis for cable routing

11.For server models with hot-swap hard disk drives, connect the power cables to the power connectors on the hot-swap hard disk drive backplanes. See “Locating connectors on the hot-swap hard disk drive backplanes” on page 37. Then, reinstall all the hot-swap hard disk drives. See “Installing a hot-swap hard disk drive” on page 60.

12.If you are instructed to return the removed power supply assembly, follow all packaging instructions and use any packaging materials that are supplied to you for shipping.

13.To complete the replacement, go to “Completing the parts replacement” on page 122.

Completing the parts replacement

This section provides instructions to help you complete the parts replacement and turn on your server.

To complete the parts replacement, you must reinstall the server cover, reconnect all the cables and, for some devices, run the Setup Utility program to do further setup.

Installing the server cover

This section provides instructions on how to install the server cover.

122ThinkServer TD230 Hardware Maintenance Manual