Lenovo TD230 manual Submenus under the Serial Port Configuration

Table 21. Submenus under the Memory RAS and Performance Configuration

Item	Option	Description
Select Memory RAS Configuration		Select the RAS configuration for
		installed memory modules.
NUMA Optimized	Disabled / [Enabled]	Whether the BIOS contains the ACPI
		configuration form required by NUMA
		OS.
Note: The settings in [ ] are the default settings in the Setup Utility program.
Table 22. Submenus under the Mass Storage Controller Configuration
Item	Option	Description
Onboard SATA Controller	Disabled / [Enabled]	Enable or disable the integrated SATA
		controller.
SATA Mode	[Enhanced] / Compatibility / AHCI /	To select the SATA mode.
	SW RAID
Note: The settings in [ ] are the default settings in the Setup Utility program.
Table 23. Submenus under the Serial Port Configuration
Item	Option	Description
Serial A Enable	Disabled / [Enabled]	Enable or disable the serial port 1 I/O.
Address	[3F8] / 2F8 / 3E8 / 2E8	Select the serial port 1 I/O address.
IRQ	3 / [4]	Select the serial port 1 I/O interruption.
Serial B Enable	Disabled / [Enabled]	Enable or disable the serial port 2 I/O.
Address	3F8 / [2F8] / 3E8 / 2E8	Select the serial port 2 I/O address.
IRQ	[3] / 4	Select the serial port 2 I/O interruption.
Note: The settings in [ ] are the default settings in the Setup Utility program.
Table 24. Submenus under the USB Configuration
Item	Option	Description
USB Controller	Disabled / [Enabled]	Enable or disable the USB function.
Legacy USB Support	Disabled / [Enabled] / Auto	Enable or disable the support on
		legacy USB devices.
Port 60/64 Emulation	Disabled / [Enabled]	Enable or disable the I/O port. This
		function is for the operating system
		that does not support on legacy USB
		devices.
Make USB Devices Non-Bootable	[Disabled] / Enabled	Set the USB device as non-bootable
		device.
Device Reset Timeout	10 sec / [20 sec] / 30 sec / 40 sec	Set the device reset timeout.
USB 2.0 Controller	[Enabled] / Disabled	Enable or disable the USB 2.0
		support.
Note: The settings in [ ] are the default settings in the Setup Utility program.

Chapter 7. Configuring the server 147