Lenovo TD230 manual Locating parts, controls, LEDs, and connectors

Note: Before clearing the CMOS, turn off the server and disconnect the power cord. Move the jumper from pins 1-2 to pins 2-3. Wait more than five minutes; then, move the jumper back to the normal position (pins 1-2 is short circuited) to clear CMOS.

Locating connectors on the hot-swap hard disk drive backplanes

There are two hot-swap hard disk drive backplanes installed in the server model with hot-swap hard disk drives. Figure 10 “Connector locations on the hot-swap hard disk drive backplanes” on page 37 shows the connector locations on the hot-swap hard disk drive backplanes.

Figure 10. Connector locations on the hot-swap hard disk drive backplanes

1

2

3

4

5

6

SATA/SAS signal connector 2 SATA/SAS signal connector 3 Power connector

Hot-swap hard disk drive 3 connector Hot-swap hard disk drive 2 connector Power connector

7Hot-swap hard disk drive 1 connector

8Hot-swap hard disk drive 0 connector

9First hot-swap hard disk drive backplane

10SATA/SAS signal connector 1

11SATA/SAS signal connector 0

12Second hot-swap hard disk drive backplane

Chapter 4. Locating parts, controls, LEDs, and connectors 37