6.Remove the optical drive retainers from both sides of the old optical drive and save them to use when you install a new optical drive.
Figure 21. Removing the optical drive retainers
7.If you are instructed to return the removed optical drive to the manufacturer, follow all packaging instructions and use any packaging materials that are supplied to you for shipping.
8.To complete the removal procedure, go to “Completing the parts replacement” on page 122.
Installing the optical drive
Attention:
Do not open your server or attempt any repair before reading and understanding the Safety Information and the Warranty and Support Information on the ThinkServer Documentation DVD that came with your product, and “Guidelines” on page 39. To obtain a copy of the publications, go to:
http://www.lenovo.com/support
This section provides instructions on how to install the optical drive.
To install the optical drive, do the following:
1.If you are replacing the optical drive, make sure that:
•You have all the cables and other equipment that is specified in the documentation that comes with the new optical drive.
•You have checked the instructions that come with the new optical drive to determine whether you must set any switches or jumpers in the optical drive.
•You have removed the optical drive retainers from both sides of the old optical drive and have them available for installation on the new optical drive.
Note: If you are installing a laser device (such as a drive), observe the following safety precautions.
Statement 3
CAUTION:
When laser products (such as
•Do not remove the covers. Removing the covers of the laser product could result in exposure to hazardous laser radiation. There are no serviceable parts inside the device.
•Use of controls or adjustments or performance of procedures other than those specified herein might result in hazardous radiation exposure.
