Lexmark C736, 25A0591 manual Parallel x menu, ENA Address, ENA Netmask, ENA Gateway

Understanding printer menus		98
	Menu item	Description
	ENA Address	Sets the network address information for an external print server that is attached to
		the printer using a USB cable
		Note: This menu item is available only if the printer is attached to an external print
		server through the USB port.
	ENA Netmask	Sets the netmask information for an external print server that is attached to the
		printer using a USB cable
		Note: This menu item is available only if the printer is attached to an external print
		server through the USB port.
	ENA Gateway	Sets the gateway information for an external print server that is attached to the printer
		using a USB cable
		Note: This menu item is available only if the printer is attached to an external print
		server through the USB port.
Parallel <x> menu
	Menu item	Description
	PCL SmartSwitch	Sets the printer to automatically switch to PCL emulation when a print job received
	On	through a serial port requires it, regardless of the default printer language
	Off	Notes:
		• On is the factory default setting.
		• When the Off setting is used, the printer does not examine incoming data.
		• When the Off setting is used, the printer uses PostScript emulation if PS
		SmartSwitch is set to On. It uses the default printer language specified in the
		Setup menu if PS SmartSwitch is set to Off.
	PS SmartSwitch	Sets the printer to automatically switch to PS emulation when a print job received
	On	through a serial port requires it, regardless of the default printer language
	Off	Notes:
		• On is the factory default setting.
		• When the Off setting is used, the printer does not examine incoming data.
		• When the Off setting is used, the printer uses PCL emulation if PCL
		SmartSwitch is set to On. It uses the default printer language specified in the
		Setup menu if PCL SmartSwitch is set to Off.
	NPA Mode	Sets the printer to perform the special processing required for bidirectional
	On	communication following the conventions defined by the NPA protocol
	Off	Notes:
	Auto	• Auto is the factory default setting.
		• Changing this setting from the printer control panel and then exiting the
		menus causes the printer to restart. The menu selection is updated.