Lexmark C762, C760 Parallel Interface, Computer to Printer, Printer to Computer Advanced Status

Models: C762 C760

1 402
Download 402 pages 23.32 Kb
Page 299
Image 299
Parallel Interface

8-7

Interfaces

Parallel Interface

Use the Lexmark 3.04 m (10 ft) parallel cable part number 1021231, or a cable that is IEEE 1284 compliant, to connect your printer to a personal computer or to a host system with a Centronics-compatible parallel port. See your printer documentation for the location of the printer parallel connector.

Note: To reset your printer with an INIT* signal, set Honor Init to On from the printer operator panel or through MarkVision Professional. See your printer documentation for more information.

Your printer can communicate with a computer across the parallel interface in three ways:

Computer to Printer

This is typically how a computer and printer communicate. When the printer is receiving data from the computer, it can use either Standard or Fastbytes protocol. The burst transfer rate in Fastbytes is faster than in Standard protocol. For best throughput, use Fastbytes protocol.

Printer to Computer (Advanced Status)

Your printer can send data to the computer. This capability lets the printer send status messages to the computer on the parallel interface.

Parallel Modes 1 and 2

These are printer features that enhance reliability of data transfer from the host computer to the printer. See “Parallel Mode 1” on page 8-14and “Parallel Mode 2” on page 8-15for more information.

Page 299
Image 299
Lexmark C762, C760 manual Parallel Interface, Computer to Printer, Printer to Computer Advanced Status, Parallel Modes 1 and