Lincoln Electric SVM134-A service manual Controls and Settings, WELDER/GENERATOR Controls

Return to Section TOC

Return to Master TOC

B-4				B-4
			OPERATION
	CONTROLS AND SETTINGS			the case front. Welding output terminals and ground
	The welder/generator	controls	are located on the
				stud are located on the machine right side, under the
	Output Control Panel	of the	machine case front.
				door. See Figure B.1, B.2 and B.3 and the explanations

Engine idler control and start/stop controls are also on	that follow.
FIGURE B.1 – OUTPUT CONTROLS

Return to Section TOC

Return to Master TOC

1

4

2

5

3

6

1.CURRENT RANGE SELECTOR

2.FINE CURRENT ADJUSTMENT

3.115 VOLT DC RECEPTACLE

4.WELD OUTPUT TERMINAL (–)

5.WELD OUTPUT TERMINAL (+)

6.GROUND STUD

Return to Section TOC

Return to Section TOC

Return to Master TOC

Return to Master TOC

WELDER/GENERATOR CONTROLS

See Figure B.1 for the location of the following features:

1.CURRENT RANGE SELECTOR: Selects ranges of continuous current output for constant current stick or TIG applications and constant voltage wire feed applications (with optional Wire Feed Module). See Control of Welding Current for more informa- tion.

2.FINE CURRENT ADJUSTMENT: Allows fine adjustment of current within the selected output range. See Control of Welding Current for more information.

3.120 VOLT DC RECEPTACLE: Connection point for supplying 120V DC power to operate DC electrical devices.

4.WELD OUTPUT TERMINAL (–) WITH FLANGE NUT: Provides the connection point for either the electrode holder or the work cable.

5.WELD OUTPUT TERMINAL (+) WITH FLANGE NUT: Provides the connection point for either the electrode holder or the work cable.

6.GROUND STUD: Provides a connection point for connecting the machine case to earth ground. See Machine Grounding in the Installation section of this manual.

CLASSIC I