Return to Master TOC
TROUBLESHOOTING & REPAIR
MAIN GENERATOR FRAME REMOVAL
AND REPLACEMENT (continued)
FIGURE F.20 – FRONT PANEL FASTENER REMOVAL
Return to Master TOC
MIDDLE SCREW (1)
BOLTS / NUTS / WASHERS (2)
BASE MOUNTING BOLTS (4)
Return to Master TOC
23.Using the 1/2” wrench, remove the two bolts, nuts, and washers that hold the front panel assembly to the horizontal rails. (There is one on each side.) See Figure F.20.
24.Using the 9/16” wrench, remove the four bolts, nuts, and washers from the bottom of the front panel assembly. These four bolts mount the front to the base. (There are two on each side.) See Figure F.20.
25.Using the 3/8” nut driver, remove the screw from the lower middle of the front panel. See Figure F.20.
26.Carefully remove the front panel assembly.
